Xerox D60327 instruction manual Troubleshooting, When installing, LAN, and PRT LEDs all flash

Problem Determination

Xerox 4500 PS TR

19.2 Troubleshooting

This chapter helps you resolve some problems you may encounter when installing, configuring or operating the Xerox 4500 PS TR.

To maintain print integrity if the Xerox 4500 PS TR is powered off, the attached printer must also be powered off. The printers can be powered off independently of the Xerox 4500 PS TR .

19.2.1 When installing

TCP/IP

The following are general guidelines for correcting problems with the installation of the Xerox 4500 PS TR.

The functioning of the LEDs on the front panel is described below:

LAN, and PRT LEDs all flash

∙Check the connection to the LAN. Reseat the LAN connector.

LAN LED continues to flash

∙Check BOOTP server definition (including BOOTPTAB file definitions)

∙Check that BOOTP server can be accessed

∙Check that the BOOTP server is running.

∙Check that the bootfile can be located (by comparing bootp type statement with file location; i.e. path).

∙Run the BOOTP server diagnostics (that is using the debug op tion with the "-d-d-d-d-d " parameters).

- use "-b" option if you have a bridged network.

∙The Xerox 4500 PS TR and an OS/2 BOOTP daemon can be separated by one or more LAN bridges or IP routers.

∙In some cases, the Xerox 4500 PS TR and OS/2 BOOTP daemon can also be separated by an IP router. The IP router must be specifically configured to pass certain broadcast frames.

NOTE: With certain IP router implementations, it is not possible to pass BOOTP requests. The Xerox 4500 PS TR and the

147