Xerox D60327 Installation of Xerox 4500 PS TR, Pre-Installation tasks, Ring speed configuration

Installation

Xerox 4500 PS TR

2. Installation of Xerox 4500 PS TR

When unpacking the unit, record the universal MAC address on the label attached to the rear panel of the unit.

Installation, configuration and changes to the mainframe and LAN of the Xerox 4500 PS TR must only be carried out by a person with authority and knowledge of the relevant environment.

CAUTION

The interface can be damaged by static discharge. To prevent this damage, the interface comes wrapped in an antistatic bag.

When you remove the interface from the bag and when you install it, hold the interface by the edges only. Do not touch the components or connections.

Do not throw away the antistatic bag. If the interface is removed from the printer later, it should be kept in the antistatic bag.

2.1 Pre-Installation tasks

Prior to installing the Xerox 4500 PS TR, you are to set

-ring speedaccording to your system requirements and

-check that language settingis correct.

Remaining switches are to be operated by support staff only.

These settings are performed on the Dip switch bank. The DIP switch bank sits on the interface

2.1.1 Ring speed configuration

ON

OFF

1 2 3 4

Dip switch number 4 is used for setting ring speed. You can select connection to the following token ring speeds:

4 Mbaud - Dip Switch must be set to OFF 16 Mbaud - Dip Switch must be set to ON

For details on network cabling connection, see the section on: “Network Installation”.

16