Xerox DocuPrint 180 manual Printer hardware components

XEROX DOCUPRINT 180 LPS HARDWARE COMPONENTS

Printer hardware components

Figure 3-6 shows the components of the Xerox DocuPrint 180 LPS printer module.

Figure 3-6.Xerox DocuPrint 180 LPS Printer

1Processor feeder trays

2Inverter-feeder/stacker module (containing inverter, high- capacity feeder, and high-capacity stacker)

3Feeder/stacker module (containing high-capacity feeder and high-capacity stacker)

4Purge tray

5Attention light

6Sample tray

7Printer control console

Note: Configuration shown in Figure 3-6 does not depict the optional Bypass Transport or Input Enablement feature devices.

Processor feeder tray 1 Located in the main part of the printer, the capacity of feeder tray 1 is 1,100 sheets of 20-pound/75-gsm paper.

Processor feeder tray 2 The capacity of feeder tray 2 is 600 sheets of 20-pound/75-gsm paper.

Trays 1 and 2 can handle paper sized from 8- by 10-inch to 9- by 14- inch/203- by 254-mm to 229- by 356-mm

High-capacity feeders (HCF)— trays 3, Each HCF can hold up to 2,600 sheets of 20-pound/75-gsm paper as 4, 5, and 6 small as 7- by 10-inch and including large paper sizes, such as

(5 and 6 optional) 11.69- by 16.54-inch (A3), 11- by 17-inch (297- by 432-mm), and 10.12- by 14-inch (B4).

High-capacity stackers (HCS) bins— A, Each HCS can hold up to 2,500 sheets of 20-pound/75-gsm paper, if B, C, and D a stacking container is not used. Printed sets can be offset in the

(C and D optional) HCS for easier separation of reports.

Sample tray The capacity of the sample tray is 100 sheets of 20-pound/75-gsm paper.

XEROX DOCUPRINT 180 LASER PRINTING SYSTEM PRODUCT GUIDE 3-5