Xerox Using your Xerox DocuPrint 180 LPS as a backup LPS, To the Xerox DP 180 LPS Operator

PRODUCT DIFFERENCES/USER CONSIDERATIONS

Using your Xerox DocuPrint 180 LPS as a backup LPS

Tables 5-1 through 5-6 identify particular job features to consider when printing a job on your Xerox DocuPrint 180 LPS which was created on another Xerox LPS running a different software version. Each table contains specific job features which may be encountered, the projected results when printed on your Xerox DocuPrint 180 LPS, and where to find further information.

Table 5-1.Will this 4635 (V3A R1.7) job print on my Xerox

DocuPrint 180 LPS

Job features from 4635
(V3A2 R1.7)	Results when run on DP 180 LPS
Programmable bypass	Job prints if DP 180 LPS has a bypass
transport	transport and the finishing device is
	required by the job. Otherwise, it does
	not run.
Clusters	Job prints. Operator needs to redefine
	clusters if trays differ.
Edgemarking	Job prints
Fonts	Job prints if the fonts and character sets
	used are loaded on the DocuPrint 180
	LPS or if substi-tutions for these fonts
	are defined.
Graphics	Job prints if sufficient graphic memory is
	available.
Labels	Job prints using only paper labels. Refer
	to the Xerox DP 180 LPS Operator
	Guide for loading instructions.
Page density	Job prints.
Paper sizes	Job prints.
Paper stock	Job prints if it does not use edge
	reinforced 3-hole stock.
Stitch commands	No stitcher available on DP 180 LPS,
	therefore stitch commands are ignored
	and job prints unstitched.
Transparencies	Job prints.
MICR	A message will appear stating that the
	system is not configured for this feature.
Bar Code	A message will appear stating that the
	system is not configured for this feature.
Interpress	A message will appear stating that the
	system is not configured for this feature.
XNS	A message will appear stating that the
	system is not configured for this feature.
Ethernet	A message will appear stating that the
	system is not configured for this feature.

XEROX DOCUPRINT 180 LASER PRINTING SYSTEM PRODUCT GUIDE 5-3