Yamaha 01V96i Gating Input Channels

Setting the Input Channels from the Display 19
01V96i—Reference Manual
Input Channels
•MIX
This parameter sets the mix balance of dry (Input Chan-
nel) and wet (delayed) signals.
•FB.GAIN
This parameter sets the amount of delay feedback.
Gating Input Channels
To set the Input Channel gates, use the [SEL] buttons to select
the desired Input Channel, then press the DISPLAY ACCESS
[DYNAMICS] button, then press the [F1] button. The
Dynamics | Gate Edit page appears.
1KEYIN SOURCE
Select one of the following buttons to determine the trig-
ger source for the currently-selected Input Channel’s gate.
•SELF.........................The selected channel’s own input sig-
nal is the trigger source.
•CHANNEL.............Another Channel’s input signal is the
trigger source. Select the desired
channel in the parameter box below
the CHANNEL button.
•AUX .........................An Aux Send signal is the trigger
source. Select the desired bus in the
parameter box below the AUX but-
ton.
2STEREO LINK
This parameter’s ON/OFF button enables you to pair
gates for stereo operation even when the Input Channels
are not paired.
3CURVE
This area displays the current gate curve.
4TYPE
This area displays the current gate type (GATE or DUCK-
ING).
5Meters
These meters indicate the levels of the post-gate signals
and the amount of gain reduction.
6ON/OFF
The ON/OFF button turns the currently-selected Input
Channel’s gate on or off.
7PARAMETER
These controls enable you to set the gate parameters. (See
page148 for more information on the parameters.)
Tip:
•This function is unavailable for the ST IN Channels.
•The delay time range depends on the sampling rate at which
the 01V96i is operating.
•If you select the DELAY SCALE meter or feet button, the dis-
tance value can be converted to the delay ti me based on sonic
speeds (about 343.59m/sec at 20 degrees Celsius). This option
is useful if you wish to correct the timing difference between
two sound sources that are far apart.
•If you select the DELAY SCALE beat button, a parameter box
for setting a note that represents the beat and a parameter box
for a tempo (BPM) setting appear below the DELAY SCALE
parameter. Setting the note and BPM settings in these param-
eter boxes enables you to set a delay time that synchronizes to
the song tempo.
3 4 521
76
Note: You cannot change the gate type on this page. To
change the gate type, recall a program that uses the desired
gate type from the Gate library.
Tip:
•This function is unavailable for the ST IN Channels.
•You can store the gate settings in the Gate library, which
features preset programs that can be used for various
applications (see page79).