38 Aux Outs
01V96i—Reference Manual

■Viewing Faders and On/Off

Parameters

To display the View | Fader page, use the corresponding [SEL]
button to select the desired Aux Out (1–8), then press the DIS-
PLAY ACCESS [VIEW] button, then press the [F2] button.
•ON/OFF
This button turns the currently-selected Aux Out (1–8)
on or off. It links with the corresponding [ON] (1–8) but-
ton in the Master layer.
•Fader
This fader sets the currently-selected Aux Out (1–8) level.
It links with the corresponding fader (1–8) in the Master
layer. The fader knob is highlighted when the fader is set
to 0.0dB.
Setting Aux Out 1–8 from the Control Surface
You can use the faders, [SEL] buttons, and various buttons
and controls in the SELECTED CHANNEL section on the
top panel to directly control certain parameters for Aux Out
1–8.

Setting Levels

To set Aux Out 1–8 levels, press the [MASTER] button in the
LAYER section to select the Master layer, then move faders
1–8. At this time, you can turn Aux Out 1–8 on or off u sing
the corresponding [ON] 1–8 buttons.

EQ settings

To control Aux Out 1–8 EQ parameters, select the desired
Aux Out (1–8) using the corresponding [SEL] button or fader,
then use the buttons and controls in the SELECTED CHAN-
NEL section. The parameters on this page (and the procedure
for setting them) are the same as for Input Channels (see
page21).
Setting Aux Send Levels
You can adjust the level of signals routed from Input Channels
to the corresponding Aux Out (1–8).

Setting Send Levels from the

Display

You can view multiple channels’ Aux Send levels on the screen
and adjust them individually.
1. Press the FADER MODE [AUX 1]–[AUX 8] but-
tons to select the Aux.
2. Make sure that the 01V96i displays the Aux |
Send page.
This page enables you to adjust the level of the signals
routed from each Input Channel to the Aux selected in
Step 1.
If the Send page is not displayed, repeatedly press the but-
ton that you pressed in Step 1 until the Send page appears.
• Aux Send rotary controls
These controls adjust the Aux Send level of the Input
Channels. The current numeric levels appear below the
rotary controls.
•PRE/POST
These buttons enable you to specify the Aux signal source
points. The PRE buttons send pre-fader signals, and the
POST buttons send post-fader signals.
•MODE
Aux Sends have two operating modes that determine how
signals are sent: Fixed (Aux Send levels are fixed); and
Variable (Aux Send levels are variable).
•GLOBAL
The GLOBAL PRE and POST buttons enable you to set
all Input Channels for the selected Aux to pre-fader or
post-fader simultaneously.
•PRE POINT
The PRE POINT PRE ON and POST ON buttons enable
you to set the pre-fader channels to pre-on (before the
[ON] button) or post-on (after the [ON] button).