30 Bus Outs
01V96i—Reference Manual
Setting the Stereo Out and Bus Out 1–8 from the Display
To set the Stereo Out and Bus Out 1–8 parameters, you can
either move the cursor to the desired parameter on the display
and change the value, or operate the desired button or control
on the top panel.
This section explains how to set the parameters on the display.

Attenuating the Stereo Out and

Bus Out

To attenuate the Stereo Out and Bus Out signals, press the
DISPLAY ACCESS [EQ] button, then press the [F4] button to
display the EQ | Out Att page. On this page, you can attenuate
the Bus Out 1–8, Aux Out 1–8, and Stereo Out signals.
The parameters on this page (and the procedure for setting
them) are the same as for Input Channels (see page20).

Delaying the Stereo Out and

Bus Outs
To delay the Stereo Out and Bus Out 1–8 signals, press the
[ /INSERT/DELAY] button repeatedly until the
/INS/DLY | Out Dly page appears.
The parameters on this page (and the procedure for setting
them) are the same as for Input Channels, except that this
page does not include the MIX/FB.GAIN parameters (see
page18).

Compressing the Stereo Out

and Bus Outs

To set the Stereo Out and Bus Out 1–8 compressors, press the
[DYNAMICS] button, then the [F3] button to display the
Dynamics | Comp Edit page, and use the [SEL] buttons to
select the Stereo Out or Bus Out 1–8.
The parameters on this page (and the procedure for setting
them) are the same as for Input Channels (see page20).
Tip: Refer to “Input & Output Patching” on page43 for more
information on how to set inserts.
Tip: You can also display the Out Dly page by pressing the
[ /INSERT/DELAY] button once, then press the [SEL] button
to select the Stereo Out or Bus Out 1–8.