Yamaha AVENTAGE RX-A2020, AVENTAGE RX-A3020 Video, ■Video Mode, ■Initial Volume, ■Pure Direct Mode, ■Adaptive DSP Level, ■Analog to Analog Conversion, Configures the video output settings

■Initial VolumeSets the initial volume when the receiver is turned on.

Settings

Off (default)	Sets the level to the volume level of the unit when it last entered
	standby mode.
	Sets at Mute or the specified volume level (-80.0 dB to +16.5 dB, 0.5
On	dB increments).
	(Specify a volume level which is lower than the “Max Volume” setting.)

■Pure Direct ModeSelects whether to output video signals during the Pure Direct mode (p.68).

Video

Configures the video output settings.

Settings

Auto (default)

Automatically outputs video signals when any videos are input from the selected input source or an input source that can be operated with the on-screen display is selected. When no video signals are input, the wall paper is displayed.

■Analog to Analog Conversion

Enables/disables the video conversion (p.156) between the analog video jacks (COMPONENT VIDEO, S VIDEO and VIDEO).

Settings

Video Off Does not output video signals including the wall paper.

■Adaptive DSP LevelSelects whether to automatically adjust the CINEMA DSP effect level.

Settings

Off Does not adjust the effect level automatically.

Off Disables the video conversion between the analog video jacks.

Enables the video conversion between the analog video jacks.

On (default) Converted video signals are output from the MONITOR OUT jacks only.

• This function works only when “Monitor Out Assign” (p.126) is set to “Main” (default) and “HDMI OUT2

Assign” (RX-A3020 only) (p.127) is set to “Main” (default) or “Zone4”.

On (default)

Adjusts the effect level automatically according to the YPAO measurement results and the volume level.

• The unit does not convert 480-line and 576-line video signals interchangeably.

• Only 480i/576i-resolution video signals can be output from the S VIDEO and VIDEO jacks (p.156).

■Video Mode

Enables/disables the video signal processing (resolution, aspect ratio and video adjustments).

Settings

Direct (default) Disables the video signal processing.

Processing

Enables the video signal processing.

Configure the settings in “Resolution”, “Aspect” and “Adjustment”.

•When “Video Mode” is set to “Direct”, the unit transmits video signals with the least circuitry in order to reduce video output delay.

CONFIGURATIONS ➤ Configuring various functions (Setup menu) En 119