Yamaha AVENTAGE RX-A2020, AVENTAGE RX-A3020 Warning messages, Cause, Remedy, Warning message, W-3:Level Error, W-1:Out of Phase, W-2:Over Distance

1 2 3 4 5 6 7 8 9 Automatic speaker setup

Warning messages

If a warning message is displayed after the measurement, you can still save the measurement results by following on-screen instructions. However, we recommend you perform YPAO again in order to use the unit with the optimal speaker settings.

Warning message	Cause	Remedy
		Select “Wiring” in “Result” (p.56) and check the cable connections (+/-) of the speaker identified by
W-1: Out of Phase	A speaker cable may be connected with the reverse polarity	“Reverse”. If the speaker is connected incorrectly, turn off the unit and then reconnect the speaker cable.
	(+/-).	Depending on the type of speakers or room environment, this message may appear even if the speakers are
		connected correctly. In this case, you can ignore the message.
W-2: Over Distance	A speaker is placed more than 24 m (80 ft) from the listening	Select “Distance” in “Result” (p.56) and move the speaker identified by “>24.00m (>80.0ft)” within 24 m (80
	position.	ft) of the listening position.
	There are significant volume differences between the	Check the usage environment and cable connections (+/-) of each speaker, and the volume of the
W-3: Level Error		subwoofer. We recommend using the same speakers or speakers with specifications that are as similar as
	speakers.
		possible.

PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO) En 59