Yamaha AVENTAGE RX-A2020, AVENTAGE RX-A3020 Error messages, Cause, Remedy, E-5:Noisy, E-7:No MIC, Error message, E-4:SBR → SBL, E-6:Check Sur, E-8:No Signal, E-2:No Sur. SP, E-1:No Front SP

1 2 3 4 5 6 7 8 9 Automatic speaker setup

Error messages

If any error message is displayed during the measurement, resolve the problem and perform YPAO again.

Error message	Cause	Remedy
E-1: No Front SP	Front speakers are not detected.
E-2: No Sur. SP	One of the surround speakers cannot be detected.	Follow the on-screen instructions to exit YPAO, turn off the unit, and then check the speaker connections.
E-3: No F.PRNS SP	One of the front presence speakers cannot be detected.
E-4: SBR → SBL	A surround back speaker is connected to the R side only.	When using only one surround back speaker, you need to connect it to the SINGLE jack (L side). Follow the
		on-screen instructions to exit YPAO, turn off the unit, and then reconnect the speaker.
E-5: Noisy	The noise is too loud.	Keep the room quiet and follow the on-screen instructions to start the measurement again. If you select
		“PROCEED”, YPAO takes the measurement again and ignores any noise detected.
E-6: Check Sur.	Surround back speakers are connected, but no surround	Surround speakers need to be connected in order to use surround back speakers. Follow the on-screen
	speakers are connected.	instructions to exit YPAO, turn off the unit, and then reconnect the speakers.
E-7: No MIC	The YPAO microphone has been removed.	Connect the YPAO microphone to the YPAO MIC jack firmly and follow the on-screen instructions to start the
		measurement again.
		Connect the YPAO microphone to the YPAO MIC jack firmly and follow the on-screen instructions to start the
E-8: No Signal	The YPAO microphone cannot detect test tones.	measurement again. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service
		center.
E-9: User Cancel	The measurement has been canceled.	Follow the on-screen instructions to start the measurement again. To cancel the measurement, select “EXIT”.
E-10: Internal Error	An internal error has occurred.	Follow the on-screen instructions to exit YPAO, turn off and on the unit. If this error occurs repeatedly, contact
		the nearest authorized Yamaha dealer or service center.
E-11: No R.PRNS SP	One of the rear presence speakers cannot be detected.	Follow the on-screen instructions to exit YPAO, turn off the unit, and then check the speaker connections.

PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO) En 58