Network

Displays the network information on the unit.

IP Address

IP address

Subnet Mask

Subnet mask

 

 

Default Gateway

The IP address of the default gateway

 

 

DNS Server (P)

The IP address of the primary DNS server

 

 

DNS Server (S)

The IP address of the secondary DNS server

 

 

MAC Address

MAC address

 

 

Network Name

Network name (the unit’s name on the network) (p.124)

 

 

Status

The connection status of the NETWORK jack

 

 

System

Displays the system information on the unit.

Remote ID

The unit’s remote control ID setting (p.133)

TV Format

The unit’s video signal type (p.134)

 

 

Speaker Impedance

The speaker impedance setting of the unit (p.133)

 

 

Tuner Freq. Step

(Asia and General models only)

The FM/AM tuning frequency setting of the unit (p.134)

 

 

 

System ID

System ID number

 

 

Firmware Version

The version of firmware installed on the unit

 

 

If the unit detects a newer firmware over the network, “!” (exclamation mark) appears at the upper right of the “Information” and “System” icons, and the corresponding message will be displayed in this screen. You can update the unit’s firmware by pressing ENTER in this screen and following the procedure in “Updating the unit’s firmware” (p.144).

Zone

Displays information about Zone2, Zone3 and Zone4 (RX-A3020 only).

Input

The input source selected for Zone2, Zone3 or Zone4

Volume

The volume for Zone2 or Zone3

 

 

Configuring the system settings (ADVANCED SETUP menu)

Configure the system settings of the unit while viewing the front display.

1Set the unit to standby mode.

2While holding down STRAIGHT on the front panel, press MAIN ZONE z.

MAIN ZONE z

STRAIGHT

PROGRAM

3Press PROGRAM to select an item.4Press STRAIGHT to select a setting.

5Press MAIN ZONE zto set the unit to standby mode and turn it on again.

The new settings take effect.
CONFIGURATIONS Configuring the system settings (ADVANCED SETUP menu)

En 132