Ide | Yamaha CRW3200NB manual

Note

•The CRW3200E drive is set at slave by default. If you connect the drive as the sole secondary master, set the drive to master.

•If you connect an IDE device solely to an IDE cable, set the device to master and connect the drive to the end of the cable.

•If you start up the operating system from a SCSI hard drive, etc., there may be no IDE device connected to the primary. In such a case, Yamaha recommends that the CRW3200E drive be connected as the primary master.

•You may find that the IDE cable has one connector when you try to connect the removed device to another connector. In such a case, you are required to prepare an IDE cable with two connectors.

•You may have to change the master/slave setting to connect the removed device to another connector. For more details, refer to the documentation that comes with the device or refer to the manufacturer’s website.

E-IDE

E-IDE (Enhanced-IDE) is a standard for connecting computers to IDE devices such as hard discs, CD-ROMs and CD-R/RW drives. Most computers have two IDE connectors (primary and secondary). Each connector can be connected to two devices with an IDE cable.

Two IDE devices connected by one IDE cable are called “master” and “slave.”

Motherboard Primary

Master

Master

Secondary Slave Slave

Continued on next page

12

Image 20

Yamaha CRW3200NB manual Ide

Contents

Page FCC Information U.S.A Achtung English Safety Precautions Iii Warranty Table of Contents Features of the CRW3200E Drive High speed writing/readingSafeBurn Enhanced stability writing technology High fidelity digital audio Names and Functions of Parts Front Panel Rear Panel Names and Functions of Parts Precautions on Use Handling DiscsCopyright Disclaimer of Indemnity Useable discs Discs that can be written onCD-R discs CD-RW discs Partial CAV Constant Angular Velocity System Requirements Computer PC/AT compatibleImage file Operating system OS Preparing the CRW3200E Drive Serial NumberPreparing tools Serial Number Decide the Installation Method Preparing the CRW3200E Drive Installing the CRW3200E drive as an additional drive Replacing an existing IDE device with the CRW3200E drive Examples of connecting the CRW3200E drive Example 1 As a secondary slave For additional drive IDE Preparing the CRW3200E Drive Set the Jumper Switch Cable Select Csel Replacing Install the CRW3200E DriveInstalling the CRW3200E drive as an additional drive Connect the included 40-pin IDE cable Connect an audio cable if necessary Audio CD playback Preparing the CRW3200E Drive Analog connection Digital connection Spdif Top Power connector Bottom When using Windows 95/98/98 Second Edition/Me Check Recognition of the CRW3200E Drive When using Windows 2000 Professional When using Windows XP When using Windows 2000 Professional/XP Check Install CD Writing Software DMA Direct Memory Access Loading/Ejecting a Disc Manually Ejecting a Disc Loading/Ejecting a Disc Troubleshooting Is the computer turned on? Disc tray does not open when you press the eject button Is the disc tray opened when the computer is restarted?Is each IDE device set respectively? Is any CD writing software being used? Disc is ejected without order or it comes out spontaneously No data can be read from a disc Playback of an audio CD CD-DA cannot be heard For Windows Me For Windows XP Is the power capacity of your computer sufficient? Error message Buffer Underrun is displayedOther problems Firmware Checking the firmware version in your CRW3200E driveYamaha CD-R/RW Drive website For Windows 95/98/98 Second Edition/Me CRW3200E Drive Specifications Supported Formats Write Read Play back *4 Data Capacity CRW3200E Drive Specifications Safety/EMC Compliance CRW3200E drive conforms to the following specifications Technical Notes Buffer Underrun Protection FunctionWriting Methods Disc-at-Once DAO Track-at-Once TAO Session-at-Once SAO Packet Writing Canada