Yamaha HTR-5835 •Tuner, •Remote control, crackling and hissing, W:ong distance o: angle, does

IIl=;,e]l]:l3.v_:[mImJIiI;[,

•Tuner

Problem

FM stereo reception is noisy.

There is distortion, and clear reception cannot be obtained even with a

FM good FM antenna.

The desired station cannot be tuned in with

the automatic tuning method.

Previously preset

stations can no longer

he tuned in.

The desired station cannot be tuned in with

the automatic tuning method.

AM There are continuous

crackling and hissing

noises,

There are buzzing and

whining noises.

Cause

The characteristics of FM stereo broadcasts n:ay cause this problem when the transmitter is too tar away or the antenna input is poo:.

The:e is multipath interfe:ence

The signal is too weak.

This unit has been disconnected for a long pe:iod

The signal is weak or the antenna

connectio:ls are loose.

Noises result fiom lightning, fluorescent lamps, n:otors, the:mostats and other electrical equipment,

A TV set is being used nearby.

								Refer
				Remedy				to page
Check		tile	antenna		connections.			19
Tly	using		a high-quality			directional	FM
antenna.
Use	the ma:mal			nming		method		33
Adjust the antenna position to eliminate
multipath			interference
Use	a high-quality				directional FM		antenna	19
Use	the manual			tuning		method		33
Preset		the	stations		again.			33
Tighten the AM loop antenna connections
and	orient		it fbr	the	best	reception
Use	the ma:mal			nming		method		33

Use an outdoor antenna and a ground wire. This will help somewhat, but it is difficult to eliminate all noise.

Move this unit away flora the T\:

•Remote control

	Problem		Cause
The	remote control		W:ong distance o: angle
does	not	work nor
function		properly,

Direct sunlight or lighting (f:om an inve:ter _,pe of fluorescent lamp, etc) is striking the remote conhol sensor of this

:::lit.

The batteries are weak.

The ren:ote conuol code was not conectly set

Even if the remote control code is correctly set, there are some n:odels that do not respond to the remote control.

			Remedy				Referto
							page
The :emote	control		will function within a maxinmm				7
range of 6 m (20 ft) and no more than 30 degrees off-
axis flora the front panel
Reposition	this	:::lit.
Replace all	batteries.						3
Set the remote		conUol		code conectly	using	"LIST OF	61
REMOTE CONTROL CODES" at the end of this
mantla].
T:y to set another			code	for the san:e	remote	conuol	61

using "LIST OF REMOTE CONTROL CODES" at the end of this manual

70