![](/images/new-backgrounds/1256027/25602777x1.webp)
AUTO SETUP (IntelliBeam)
■Error messages for AUTO SETUP
Before the AUTO SETUP procedure starts
Error message | Cause | Remedy | See | |
page | ||||
|
|
| ||
|
|
|
| |
ERROR | The IntelliBeam microphone is not | Connect the IntelliBeam microphone to | 32 | |
No MIC detected. Please check | connected to this unit. | this unit. |
| |
MIC connection and |
|
|
| |
|
|
|
|
While the AUTO SETUP procedure is in progress
If one of the errors listed below except
Error message | Cause | Remedy | See | |
page | ||||
|
|
| ||
|
|
|
| |
ERROR | There is too much unwanted noise in | Make sure that your listening room is as | — | |
Please test in quieter environment. | your listening room. | quiet as possible. You may want to |
| |
|
| choose certain hours during the day |
| |
|
| when there is not much noise coming |
| |
|
| from outside. |
| |
|
|
|
| |
ERROR | The IntelliBeam microphone was | Make sure that the IntelliBeam | 32 | |
No MIC detected. Please check | disconnected while the AUTO SETUP | microphone is firmly connected to this |
| |
MIC connection and | procedure was in progress. | unit. |
| |
|
|
|
| |
ERROR | Some other operations were performed | Do not perform any other operations | — | |
Unexpected control is detected. | on this unit while the AUTO SETUP | while the AUTO SETUP procedure is in |
| |
Please | procedure was in progress. | progress. |
| |
|
|
|
| |
ERROR | The IntelliBeam microphone is not | Make sure that the IntelliBeam | 32 | |
Please check MIC position. MIC | placed in front of this unit. | microphone is installed in front of this |
| |
should be set in front of YSP. |
| unit. |
| |
|
|
|
| |
ERROR | The IntelliBeam microphone is not | Make sure that the IntelliBeam | 32 | |
Please check MIC position. MIC | placed in the right distance from this | microphone is installed more than 1.8 m |
| |
should be set above 1.8m/6.0ft. | unit. | (6.0 ft) from the front of this unit and |
| |
|
| within 1 m (3.3 ft) from the center height |
| |
|
| of this unit. |
| |
|
|
|
| |
ERROR | The IntelliBeam microphone cannot | Make sure that the IntelliBeam | 32 | |
Volume level is lower than | collect the sound produced by this unit | microphone is firmly connected to this |
| |
expected. Please check MIC | because the sound output level is too low. | unit and placed in a proper location. If |
| |
position/connection and |
| the problem persists, contact the nearest |
| |
|
| authorized Yamaha service center for |
| |
|
| assistance. |
| |
|
|
|
| |
ERROR | An internal system error occurred. | Repeat the AUTO SETUP procedure. | — | |
Unexpected error happened. |
|
|
| |
Please |
|
|
| |
|
|
|
|
SETUP
English