![](/images/new-backgrounds/1256027/25602775x1.webp)
AUTO SETUP (IntelliBeam)
8Check that the following screen is displayed on your TV.
The results of the AUTO SETUP procedure are displayed on your TV.
Example 1
SHOW RESULT
MEASUREMENT COMPLETE | ← Flashes |
BEAM MODE :5 BEAM
SUBWOOFER :NOT APPLICABLE
[ENTER]:Save
Example 2
SHOW RESULT
MEASUREMENT COMPLETE | ← Flashes |
ENVIRONMENT CHECK[FAILED]
BEAM MODE :5 BEAM
SUBWOOFER :YES
[ENTER]:Save
y
•If “ENVIRONMENT CHECK [FAILED]” is displayed, we recommend running the AUTO SETUP procedure again. For details, see step 9.
•If “SUBWOOFER : NOT APPLICABLE” is displayed even though a subwoofer is connected to this unit, increase the volume level of the subwoofer and run the AUTO SETUP procedure again.
•Depending on the environment of your listening room, the beam angle of front left and right, and surround left and right may be set to the same value even if
“5 BEAM” is displayed as a result.
9Press ENTER to confirm the results or press RETURN to cancel the results.
The following screen is displayed for two seconds and then disappears from your TV.
AUTO SETUP COMPLETE
Please remove the MIC from
ENTERthe YSP and the listening position.
If “ENVIRONMENT CHECK [FAILED]” is displayed in step 8, the following screen is displayed after pressing ENTER. In this case, see ERROR
AUTO SETUP COMPLETE
Your YSP unit may not be set up correctly.
We recommend you try again.
Please press [ENTER] key to exit.
10Disconnect the IntelliBeam microphone from the INTELLIBEAM MIC jack on the front panel.
y
If you want to save and load settings, see “Using the system memory” on page 38.