Yamaha PRO/Mark IV manual Preparing the Pocket Controller

CHAPTER 1: Getting Started

Preparing the Pocket

Controller

1 Remove the card slot protector, and then insert the supplied CF wireless LAN card into the CF card slot.

2 Set the battery replacement switch to

the [REPLACE BATTERY] position.

NORMAL OPERATION

REPLACE BATTERY

3 Put the rechargeable battery into the battery compartment.

Make sure that the , and marks on the battery are aligned correctly with those printed inside the battery compartment.

4 Set the battery replacement switch back to the [NORMAL OPERATION] position.

5 Remove the I/O port cover, and then set the Pocket Controller on the cradle.

I/O port cover

Charge indicator

Charging starts and the charge indicator lights amber. When the battery is fully charged, the indicator goes out.

Notes on Rechargeable Battery

The rechargeable battery used in the Pocket Controller should last for one to two years under ordinary usage. When in use, the battery should hold a charge for 60 to 90 minutes. If the battery loses its ability to hold a charge or recharging cannot be completed, contact your nearest dealer and replace the rechargeable battery.

Use the following methods to increase the life of the rechargeable battery:

•For normal use, disconnect the Cradle from the “EA-70” AC adaptor, and reconnect it only when recharging.

•Turn off or dim the backlight of the Pocket Controller’s touch screen with [Light & Power] setup.

•When the Pocket Controller is not in use, hold down

for approximately two seconds to turn off the Pocket Controller.

•When the Pocket Controller is not used for a long period of time, remove the rechargeable battery.

15