Getting Started, Media Center | Yamaha PRO/Mark IV guide

CHAPTER

1 Getting Started

Items Supplied with the Disklavier

Make sure the following items are supplied with your Disklavier:

•Media Center (1)

•Installation kit for the Media Center (1 set)

•Monitor speaker (2)*

•Installation kit for the monitor speaker (1 set)*

•Speaker cord (2)*

•Pocket Controller PRC-100 (1)

•CF wireless LAN card (2)**

•Rechargeable battery EA-BL08 (1)

•Cradle (1)

•AC adaptor EA-70 (1)

•AC power cord (1)

•Advanced Operating manual (this book) (1)

•Quick Guide (1)

•Stereo headphones (1 set)

*Only for models supplied with the Monitor speakers. **One of two cards is attached to the I/O Center at the factory.

Names of Parts and Their Functions

Media Center

— Front —

				Note: The location of
STANDBY/ON	QUIET	User PianoSoft CD	FD	each unit differs
				each unit differs
	REC		VOL.	depending on the model.
			CLOSE	depending on the model.
			OPEN/

ASTANDBY/ON button

Pressing the button turns the Disklavier on or puts it in Standby mode.

Holding down the button shuts down the Disklavier.

BQUIET button

Activates the Quiet Mode.

CSource Select buttons

Starts or stops playback of the songs stored in the corresponding library/medium.

User: Selects the User Library.

PianoSoft: Selects the PianoSoft Library.

CD: Selects the loaded CD.

FD: Selects the loaded floppy disk.

DFront lid

Draw and swing down to cover the front panel.

ECD tray

→pg. 20 “Loading a CD”

FFloppy disk drive

→pg. 20 “Loading and Ejecting a Floppy Disk”

1

Image 14

Yamaha PRO/Mark IV Getting Started, Items Supplied with the Disklavier, Names of Parts and Their Functions, Media Center

Contents

Page Important Notice For the United Kingdom Special Message Section Important Safety Instructions Statements Regarding the Wireless LAN Card FCC Information U.S.A English Page Introduction Trademarks & Copyrights Important Precautions Interference Handling Rechargeable BatteryMaking Backups on a Regular Basis Exclusion of Liability for Loss of Data Table of Contents Troubleshooting Other SettingsInternet Direct Connection IDC Service Error Messages Names of Parts and Their Functions Getting StartedItems Supplied with the Disklavier Media Center Getting Started Eject button Center Front Output jacks Getting Started Left side Central Signal Processor Power Supply Unit Getting Started Right side Charge indicator amber Pocket Controller Getting Started Rear Cradle LINE1/2 volume controls Monitor Speakers Screw the supplied screws into the nuts Setting Up the DisklavierInstalling the Media Center Attach the hanger to the bottom Screw the thumbscrews to secure the Monitor Speaker Wiring the Disklavier Monitor speaker Left Right Sensor Preparing the Pocket Controller Calibrating the Touch Screen Initial Settings of the Pocket ControllerSetting up the Current Date and Time Tap on Date/Time in the PRC Menu screen Adding Your City to the Time Zone Drop Down List 10Reboot the Pocket ControllerRebooting the Pocket Controller To correct the city selection, tap on Resetting the Pocket Controller Pairing the Pocket Controller and the Disklavier Write Protection Basic Precautions for Using Floppy Disks and CDsHandling Floppy Disks Description of the Task Bar Available File Format Structure of Data Removable Media Getting Started Changing the Playback Tempo Song Playback FeaturesTo cancel the transposition, set the value to Playing Back Songs in a Different Key Transposition Repeating a Specific Section of a Song A-B Repeat To cancel repeat mode, tap on in stepRepeating Song Playback Tap on Song screen Tap on the desired repeat mode, Then on To clear the registered point, tap on Playing Back Only Desired Piano PartTap on at the end of the section you want to repeat point B Tap on to clear the Balance control screen Tap on the desired part to change its setting play or muteUtilizing the Play Lists Adding the Desired Song to the Play Lists Tap on After the completion Message appears To cancel this operation, tap onTemporarily Changing the Voice of a Track Playing Back the Desired Songs in the Desired Order Tap on Voice Tap on the desired voice name Tapscreen.on once on the Song Editing TracksMix/Move/Copy Track Tap on the desired edit track option Button Delete Track Transpose Track Checking the Song Information Song-Info Screen Tap on / to adjust the transposition value, and then tap onChecking and Modifying the Song Information Checking and Modifying the Song Information Song-Tag screen Modify the information Entering Characters Presetting Playback Control Options for Each Song Tap on the title of the desired option Follow and play the prompt key SmartKey PlaybackKey notation Selecting the Part to Be Guided Video Synchronized Playback Copying Song File from a Personal Computer to the Disklavier For Windows For Mac OS X 10.3 or later For Windows onlyTap on in the Main screen Tap on , and then Case that you cannot find the Dkv****** icon Playing the Disklavier along with the Internal Metronome Piano Playing FeaturesTap on / to adjust the value of the desired option Tap on in the Main screen Tapmetronome.onto start To complete Adding Expressive Effect to Your PlayTappart.on the voice name of the desired Adding Chords to a Melody Line Harmony Mode Setting up Harmony Mode Tap on in the Main screen Then on Playing the Disklavier in Harmony ModeApplying Reverb Effects to the Digital Piano Press to stop recording RecordingRecording a New Song To play back the recorded song, press Press REC on the Media Center Quick RecordingTitling a Song at the Start of Recording Press User to start recording Press to start, and then immediately pause recording Setting Up the Camcorder and the DisklavierVideo Synchronized Recording Hook up a camcorder to the I/O Center Pressvalue. select button to set To cancel the adjustment, pressTap on to turn the video synchronization on Starting Video Synchronized Recording Start playing the Disklavier Press to stop recording CD Synchronized RecordingRecording Ensemble Parts Ensemble Part Recording and Track Structure Tapvoice.on Voice, and then the desired To cancel recording, tap onTap on the track number to be overwritten in the track list Tap on Twice Overdubbing an ExistingPart Overdubbing a Piano Part Overwriting a Part on an Existing Song To cancel recording, tap on EnglishMaking a New Recording To cancel Quantize function, select OFF Quantize Function Time Mode Changing the Default TempoTap on / of Tempo to adjust the tempo Metronome Mode To clear the Function Menu screen, tap on Creating a Song LibraryCreating an Album in the Library To name the new album, see Copy the selected song or album Renaming an AlbumMaking Copies of Songs or Albums Copying a Song Copying an Album SEQ Piano1 format conversion To cancel deletion, tap on Deleting Songs or Albums Rearranging the Order Songs/Albums Skipping the Blank Part at the Beginning of a Song Other SettingsUsing Timer Play Inactivating the Key Movement During Playback To delete all timer program settings, tap Taplist. on the desired row in the timer10Tap on to complete the setting Tap on Day, and then press to select the desired day Tuning the Tone Generator MasterTune To cancel tuning, tap on 11Tap on to clear the Vocal Harmony screen 10Tap on to activate Vocal Harmony modeTaptype.on the desired vocal harmony Connect a foot control/switch to the Foot CNTRL1/2 jack Preparing for Use of Foot Controls/SwitchesSetting Up the Disklavier for Foot Controls/Switches Select the detailed setting When Pitch Bend is selected Tap on to complete the settingOperating an Optional Foot Switch FC4/FC5 When Play/Stop is selected for Function Output+PianoTG Hooking Up AV EquipmentAnalog MIDI-YM Hook up a TV or a monitor display to the I/O Center Lyric ScreenDigital Out Changing the Background Picture of the Lyric Screen Converting Midi Data to a Standard Form Strip XPStart playback of a song with lyrics on the Disklavier Restoring the Song Library Making Backups and Restoring the Song LibraryMaking Backups Tap on After the completion Message appears, and then Formatting a Floppy Disk Restoring the Contents in the Demo AlbumMaking an Install Floppy Disk Assigning a Specific Function to the ONE Touch Button Resetting the DisklavierTap on To start resetting Diagnosing the Disklavier Piano Voice List Instrument Voice Name Group Ensemble Part Playback Voice List Group Name Voice Voice Name Number XG-Marimba Other Settings Brass Group Name Voice Voice Name Number Effects 399 XG-HollwRls Synth 433 XG-Banjo SFX Voice English Continue to next Drum Voice ListVocal Harmony Type List Vocal Harmony Type Mode ChromaticXG Voice & Inst Vocoder Hooking Up a Midi Device Hooking Up a Midi Device Port Setting Up the Disklavier for Midi Data Reception MidiDelay Piano Rcv Ch Transmit Part Esbl Out Split Out ChLocal Trans L InternetService Direct Connection IDC What is Internet Direct Connection IDC? Preparations Connecting the Disklavier to the InternetConnecting the I/O Center to the Internet Connection example Accessing the Internet List Screen Basic Operations on the IDC Service ScreensDisklavierRadio Play Screen Purchase Screen Checking Your Account Information Logging Out from IDC ServicePerform of Accessing the Internet. → pg Tap on , and then Tap on to return to the Internet screen Perform of Accessing the Internet. → pg Tap on Accessing the Download LibraryUpdating the Disklavier Using the Internet English Use Dhcp Setting Up the Disklavier for Internet ConnectionTap on the desired option or DNS1/DNS2 Proxy Server/Proxy Port Initializing Internet SettingsIP Addr./Sub Mask/Gateway Delete Cookie Troubleshooting Some notes drop out during playback Disklavier does not recognize an USB flash memoryDisklavier does not read a CD-R/-RW PianoSmart playback cannot be performed Error Messages Situation Error Messages Description Screen Transition Diagrams Main screens Rec screens English Song screens Setup menu screens Song playback option buttons English Setup option screens 100 Glossary Internet Half PedalIncremental Pedal IP address Reverb Quiet ModeSound Muting Mode Rhythm Track Website VoiceWeb 104 105 SpecificationsGeneral Features 106 107