Zebra Technologies TTP 2030 manual Partial Cut Width, Presenter Loop Length, Eject Length

14

Windows CE Driver

Printer Settings

Partial Cut Width

Partial cut leaves multi-page receipts attached at the specified width. The partial cut width can be set to 0 and between 10 and 60 mm; the default is 0 and it disables partial cut (full cut). Partial cut can only be used with the Cut at document end selection in Cutter Mode.

Page 1

10 mm

Page 2

Page 1

60 mm

Page 2

Cut

Not Cut

Figure 4 • Partial Cut Diagram

Presenter Loop Length

Presenter Loop Length determines how much paper is held in the presenter loop. The presenter loop length can be set between 0 and 600 mm and the default value is 416 mm. A setting of 0 disables the presenter loop and media feed directly through the presenter.

Eject Length

Eject Length determines how much paper is exposed for the customer. The range is from 20mm to 600mm with the default set to 50mm. If the eject length is set larger than the length of the receipt, the printer will retain a portion of the receipt in the presenter unless the “Clear Presenter” option is set to “Enable”.

Present Length Addition

Presenter Length Addition is an additional length to compensate for the thickness of the kiosk wall. The range is from 0 to 255 mm with the default set to 0.

Presenter Timeout

Presenter Timeout determines how long the presenter will hold the receipt before ejecting it. The range for the timeout is from 0 to 300 seconds with the default set at 0.

Note • Presenter timeout value must have a minimum of 10 seconds in order to work properly.

P1055866-001 TTP 2030™ Windows CE Software Integrator Guide 4/14/2013