Zebra Technologies TTP 2100 manual Power Indicator, Status Indicator

12

Product Presentation

Controls

Power Indicator

●When the green power indicator is illuminated, a 24V supply is connected to the printer.

Status Indicator

●The status indicator has several functions:

• ON constantly — the printer is operational

•Flash, flash, pause, flash, flash — is the warning-code for paper low.

The warning-code is reset automatically when the condition causing it is removed. This behavior is disabled by default but can be enabled by setting parameter 52 (Warning Level) to 1.

•Flashes rapidly — indicates error. Hold down the Feed button and the number of flashes will reflect the status-code.

	Table 1 • Status Indicator Flash Codes
Number of	Description
Flashes
1	Presenter jam, paper cannot be ejected
2	Cutter cannot return to home position
3	Out of paper
4	Printhead lifted
5	Paper did not reach presenter sensor in time
6	Temp error, printhead is above 60°C
7	Paper jam during present
10	TOF mark not found (on media load)
11	TOF mark calibration error
Fast flashes	Checksum error at firmware loading
Steady light	Wrong firmware type
Constantly off	Waiting for paper in TOF mark calibration mode

Status codes are reset:

•When the conditions causing them are removed

•When the printer is power cycled (turned off and then on)

•For all paper jam conditions, after the jam is cleared, lifting and lowering the printhead.

P1021708-001 TTP 2100 Operator Guide 11/04/2009