Installation and Setup
Setting the Card Thickness Control
Card Thickness
Control
3.There are four detents to set the position of the Card Thickness Control. Slide the Card Thickness Control to the position corresponding to the following:
Detent Position | Card Thickness |
|
|
Highest | 50 mil (1.27 mm) to 60 mil (1.52 mm) |
|
|
3rd position | 30 mil (0.76 mm) to 50 mil (1.27 mm) |
|
|
2nd position | 20 mil (0.51 mm) to 40 mil (1.02 mm) |
|
|
Lowest | 10 mil (0.25 mm) to 20 mil (0.51 mm) |
|
|
Note • The overlap in settings above accomodates variations in environmental conditions (especially humidity) and cards from different manufacturers. In general, start at the lowest position and move the lever up until cards feed reliably.
Note • “60 mil” (“1.524 mm”) cards may have a significant variation (over 10%) in the actual thickness of the cards; do not use these cards unless each card has been measured to have a thickness less than 66 mil (1.676 mm).
P330i User’s Manual | 17 |
