Zebra Technologies ZQ110 manual Msw

									ZQ110
<Function 3> GS ( E pL pH fn [a1 b18...b11]...[ak bk8...bk1]								(fn=3)
[Format]	ASCII	GS	(	E	pL	pH	fn		[b18...b11]... [bk8...bk1]
	Hex	1D	28	45	pL	pH	fn		[b18...b11]... [bk8...bk1]
	Decimal	29	40	69	pL	pH	fn		[b18...b11]... [bk8...bk1]
[Range]	10 ≤ (pL + pH x 256) ≤ 65535
	fn=3
	a= 1, 2, 5, 6, 7, 8
	b=48, 49, 50
	1 ≤ k ≤ 10
[Default]	It varies depending on the printer model

▪This command terminates the user setting mode and performs a software reset.

[Description] This command changes all the Memory Switch(MSW) 1 through 8 to the value specified by b simultaneously as follows:

-When b=48, 49, the corresponding bit is set to Off and On respectively.

-When b=50, there is no change in the memory switch.

▪The setting items of the memory switch 1 are as follows:

	MSW					Value				Function
			3			2		1
		48			48		48			Print density 130%
		48			48		49			Print density 120%
		48			49		48			Print density 110%
1-1~3		48			49		49			Print density 150%
		49			48		48			Print density 100%
		49			48		49			Print density 140%
		49			49		48			Print density 90%
		49			49		49			Print density 80%
	MSW			Value						Function
1-4				48					2 byte character mode not selected
				49					2 byte character mode selected
1-5				48					Print speed 90mm/s
				49					Print speed 50mm/s
1-6				48					Reserved

-The print density adjusts the darkness of characters to be printed.

-2-byte character mode is selected to support for Chinese, Japanese, and Korean model.

-The printer supports 2 different printing speeds, 90mm/sec and 50mm/sec.

Please be sure that the printing quality at higher speed may be worse than at the lower.

Rev. 1.00 - 61 - Mobile Printer Command Manual