Zebra Technologies ZQ110 manual

ZQ110

▪The setting items of the memory switch 8 are as follows:

-Either the character font A or B or C is selected.

-The beep is activated for the audible paper empty warning signal.

-The beep is activated for the audible low battery warning signal.

-The label printing is available by the setting.

MSW		Setting Value	Function
8-1		Refer to the following Table 1
8-2
8-3	48		No beeps for roll paper end
	49		Beeps for roll paper end
8-4	48		Beeps for low battery status
	49		No beeps for low battery status
8-5	48		Blackmark mode disable
	49		Blackmark mode enable
8-6		Refer to the following Table2
8-7
8-8	48		Reserved

Table 1

Function	MSW 8-2	MSW 8-1
Select font 12x24	48	48
Select font 9x17	48	49
Select font 9x24	49	48

Table 2

Function	MSW 8-8	MSW 8-7	MSW 8-6
Fixed multi byte sentinel characters &	49	49	48
encryption MSR data.

-When set to Multi-byte sentinel characters mode, the header and the footer, which have been used in normal mode, are not used any more and the specified Start characters and End characters are added to the beginning parts and the end parts of each track data to be transmitted.

-When set to Multi-byte sentinel characters mode but Start characters and End characters are not set by fn2 and fn3 of BS M S command respectively, the default Start and End characters are applied to MSR data to be transmitted to host.

-When set to Multi-byte sentinel characters mode, <CR/LF> characters after End characters of each track data are automatically applied to the card data to be transmitted to host.

Rev. 1.00 - 64 - Mobile Printer Command Manual