Parameter reference | Alphabetical Reference |
Specify a value from 0 to 100ms in multiples of 10.
Configuration group: DPCFG
Syntax: (GET/SET)
CUR
Current T1
•ES (errored seconds): indicates the total number of seconds in which one or more frames with
•SES (severely errored second): indicates the total number of seconds in which the bit error rate exceeded one bit per thousand (1 x
•BES (bursty errored second): indicates the total number of seconds with more than one and fewer than 320
•UAS (unavailable second): indicates the total number of seconds during which service is unavailable. An unavailable signal state is declared after ten consecutive SESs are logged. An unavailable state is cleared after ten consecutive
•LOFC (loss of frame count): indicates the total number of times a Loss Of Frame (LOF) is declared. An LOF is declared after 2.5 seconds of a continuous Loss Of Synchronization (LOS) or
•SLIP: (slipped second): indicates the total number of seconds that contain one or more controlled slips. A controlled slip is the deletion or replication of a T1 frame by the receiving equipment.
DS0
Specifies whether the DS0 management interface is enabled. When enabled, the DS0 management channel encapsulates IP traffic in HDLC frames using DS0 24. Possible values are:
•ON
•OFF (default)
Configuration group: T1CFG
Syntax: (GET/SET) T1CFG:DS0:X:(ON/OFF)