REGULATORY INFORMATION
Federal Communications Commission (FCC)
Part 15 Regulation For Telephone Equipment
The product described herein has been tested and found to comply with the limits for a Class “A” Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used according to instructions in this Operations Manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their expense.
The authority to operate this equipment is conditioned on the requirement that no modifications will be made to the equipment unless the changes or modifications are expressly approved by the manufacturer.
This equipment was tested with shielded input/output and interface cables. It is recommended that shielded cables be used with the equipment to reduce interference whenever the possibility of interference is suspected.
FCC Part 68 Regulatory Information
Notice to Users of T1 Service
This equipment complies with part 68 of the FCC rules. On the bottom of the chassis is a label that contains, among other information, the FCC certification number of this system. If requested, this information must be provided to the telephone company.
The applicable certification jack (USOC) used on this equipment is the RJ48C. Before connecting your unit, you must inform the telephone company of the following information:
Port ID | REN/SOC | FIC | USOC |
|
|
|
|
6.0Y | RJ48C | ||
|
|
|
|
6.0Y | RJ48C | ||
|
|
|
|
6.0Y | RJ48C | ||
|
|
|
|
6.0Y | RJ48C | ||
|
|
|
|
6.0Y | RJ48C | ||
|
|
|
|
This equipment is designed to be connected to the telephone network or premises wiring using a compatible modular jack that is part 68 compliant. See installation instructions for details. Note that the Ringer Equivalence Number (or REN), is not applicable for this system’s T1 digital ports.
