Changing the Patch Call Method
In the factory default condition, patches are switched as soon as you make the selection, resulting in an immediate change in the sound. If you want to change to a distant patch, all the intermediate patches will briefly change the sound, which may not be desirable, especially during a performance. In such a case, you can change to the preselect method.
When the preselect method is enabled, you first select the desired patch, but the sound does not change until confirmed by you.
1.To change the patch call method to preselect, hold down the [Q] foot switch while turning power to the 707II on.
2.Select the patch in play mode.When you select a patch in this condition, the display and [BANK/PATCH] indicator show the new patch (flashing), but the sound does not change.
A0
A1
A2
A3
The display and [BANK/PATCH] indicator stop flashing, and the unit switches to the new patch, causing the sound to change.
| confirmed |
A3 | A3 |
HINT 
To return to the default patch selection method, turn the 707II off and on again.
Using the Pedal to Control an Effect
You can use the expression pedal of the 707II to control the parameter, on/off status, or volume level of a specific effect. The pedal adjustment range can be memorized individually for a patch.
2.Use the [PEDAL] key to select the module/effect type to be controlled with the expression pedal.
Each push of the [PEDAL] key cycles through the [PEDAL] LEDs as shown below.
LitOut(Pedal is inactive)
The [PEDAL] LEDs indicate the module/effect type assigned to the pedal. The meaning of the LEDs is explained below.
●WAHThe expression pedal functions as a pedal wah. The effect type
The expression pedal functions as a pitch shifter. The effect type
Functions Other
ZOOM 707II GUITAR 23