Zoom 7072 ●MOD, ●REV, ●VOL, ●GAIN, ●SAMPLER, 24ZOOM 707II GUITAR, 5.Press the [EDIT] key once more, 3.Press the [EDIT] key to activate the edit mode

Functions Other

MODULATION module, the effect type is temporarily switched to P-PIT.

●MOD

The effect type currently selected for the MODULATION module is adjusted by the pedal. Which parameter is controlled depends on the effect type.

●GAIN

The distortion gain is adjusted by the pedal. The GAIN parameter of the DRIVE module (for some effect types the RESONANCE/TOP parameter) is assigned to the pedal.

●REV

The effect type currently selected for the DLY/REV module is adjusted by the pedal. Which parameter is controlled depends on the effect type.

●VOL

The master volume is adjusted by the pedal.

●SAMPLER

The sampler function is switched on/off by the pedal. Pushing the pedal all the way down toggles between sampler on ([PEDAL] LED lit) and sampler off ([PEDAL] LED flashed).

Also if a module is currently off, selecting it with the [PEDAL] key will cause its [PEDAL] LED to light and the module will temporarily come on. If a patch is stored in this condition, the module will be stored as ON.

The actual parameter that is controlled by the pedal depends on the effect type. For details, see p. 33 – 38.

HINT

The above procedure for assigning a module/effect type to the expression pedal can be carried out also in edit mode.

3.Press the [EDIT] key to activate the edit mode.4.Use the MODULE [E]/[R] keys to select the TOTAL module.

5.Press the [EDIT] key once more.

The key lights up in green. In this condition, parameter knobs 2 and 3 have the following functions.

Lit	Parameter knob 2
	Sets the value for the
	fully raised position
	of the pedal.

Parameter knob 3 Sets the value for the fully lowered position of the pedal.

6.Use parameter knobs 2 and 3 to set the PDLMIN value (when pedal is fully raised) and PDLMAX value (when pedal is fully lowered). The setting range for both values is 0 – 10.

When you operate parameter knob 2, the indication "PDLMIN" appears on the display. When you operate parameter knob 3, the indication "PDLMAX" appears on the display. The 0 – 10 value is shown on the [BANK/ PATCH] indicator.

Setting PDLMIN or PDLMAX to 0 means that the parameter assigned to the pedal will be at the minimum value. Setting PDLMIN or PDLMAX to 10 means that the parameter assigned to the pedal will be at the maximum value.

When the 707II is in the default condition, PDLMIN is set to 0 and PDLMAX is set to 10. As the pedal is depressed, the parameter value gradually increases from minimum to maximum.

MAX=10

MIN=0

24ZOOM 707II GUITAR