Listening to Patches (Play Mode Operation)
The condition where you call up patches stored in the memory of the 707II and use them for playing your instrument is called "play mode". This is the condition the unit is in when you turn the power on. The various operations possible in play mode are described in this section.
Panel Display in Play Mode
In play mode, the panel shows the following information.
Patch name | Bank (A - F, 0 - 5) | |
Patch number (0 - 9) | ||
|
A0
Module LEDs corresponding to modules that are ON in the currently selected patch are lit.
When a dot (.) is shown here, an effect parameter has been changed.
When a dot (.) is shown here, patches can be selected from either the USER group or the PRESET group.
Operation) Mode (Play Patches to Listening
Selecting a Patch
1.In play mode, press one of the [W]/[Q] foot switches.Pressing the [Q] foot switch moves to the next higher patch, and pressing the [W] foot switch moves to the next lower patch.
USER group
A0 
A1 
A9 
B0 
F9
00 
01 
09 
10 
59
Pressing the TYPE [Q] key moves to the next higher bank, and pressing the TYPE [W] key moves to the next lower bank.
NOTE 
While playing a rhythm pattern, direct bank selection is not available.
3.It is also possible to set up the unit so that only patches from the USER group or from the PRESET group are switched. To do this, press both TYPE [W]/[Q] keys together.
With each push, the group from which patches can be selected is toggled as follows.
Both groups | USER group | PRESET group |
| only | only |
02 | A2 | 02 |
HINT 
To set up the unit so that the patch sound is switched only after confirmation, see p. 23.