∙PPP Options: Recv. Authen. - verify that this field is not set to None Bridging applications must have some sort of authentication turned on in order to match to a Remote Node.
Once you have completed filling in the menu, press ENTER at the message: Press ENTER to Confirm ... to save your selections, or press ESC at any time to cancel your selections.
Bridge Static Route Setup
You can configure Bridge static routes for your Bridging applications.
Figure 9-3 Menu 12.4 - Bridge Static Route
1.Route Name - For identification purposes enter a name for the bridge static route.
2.Active - Indicates whether the static route is active or not.
3.Ether Address
4.IP Address - If available, enter the IP address of the destination device that you wish to bridge your packets to.
5.Gateway Node - Enter the number
Bridging Configuration 93
