ZyXEL Communications 314 PLUS 7.5.2 Remote Node Filters, protocol filters, protocol filters, Call Filter Sets, Output Filter Sets, Figure 7-16Filtering LAN Traffic

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch

Menu 3.1 – LAN Port Filter Setup

Input Filter Sets: protocol filters= 2 device filters= Output Filter Sets: Protocol filters=

device filters=

Press ENTER to Confirm or ESC to Cancel:

Apply

factory

default

filter

here.

Figure 7-16 Filtering LAN Traffic

7.5.2 Remote Node Filters

Go to menu 11.5 (shown next – note that call filter sets are only present for PPPoE encapsulation) and enter the number(s) of the filter set(s) as appropriate. You can cascade up to four filter sets by entering their numbers separated by commas. The factory default filter set, NetBIOS_WAN, can be applied in menu 11.5 to block local NetBIOS traffic from triggering calls to the ISP (when you are using PPPoE or PPTP encapsulation only). Enter 1 in protocol filters under Output Filter Sets when using Ethernet encapsulation, and in the protocol filters field under Call Filter Sets when using PPPoE or PPTP encapsulation. Apply them as shown in the following figure.

Menu 11.5 - Remote	Node Filter
Input Filter Sets:
	3	Apply
protocol filters=
device filters=		factory
Output Filter Sets:	1
protocol filters=		default
device filters=		Filters
Call Filter Sets:	1
protocol filters=		here.
device filters=

Enter here to CONFIRM or ESC to CANCEL:

Figure 7-17 Filtering Remote Node Traffic

Filter Configuration 7-19