ZyXEL Communications 314 PLUS Table 10-2Traffic Redirect Setup, Figure 10-4Menu 11.6 — Traffic Redirect Setup

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch

Menu 11.6 - Traffic Redirect Setup

Active= Yes

Configuration:

Backup Gateway IP Address= 0.0.0.0

Metric= 15

Check WAN IP Address= 0.0.0.0

Fail Tolerance= 2

Period (sec)= 5

Timeout (sec)= 3

Press ENTER to Confirm or ESC to Cancel:

Press Space Bar to Toggle.

Figure 10-4 Menu 11.6 — Traffic Redirect SetupTable 10-2 Traffic Redirect Setup

FIELD	DESCRIPTION	EXAMPLE
Active	Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic	Yes
	redirect setup. The default is No.
	When the Active field is Yes, you must configure every field in this screen
	unless you are using PPPoE or PPTP encapsulation (except Check WAN
	IP Address and Timeout).
	If you don’t configure these fields and are using PPTP or PPPoE
	encapsulation, then the Prestige checks the PPPoE channel or PPTP
	tunnel to determine if the WAN connection is down.
Configuration:
Backup	Enter the IP address of your backup gateway in dotted decimal notation.	0.0.0.0
Gateway IP	The Prestige automatically forwards traffic to this IP address if the
Address
	Prestige’s Internet connection terminates.
Metric	Enter a number from 1 to 15 to set this route’s priority among the	15
	Prestige’s routes (see Metric on page 10-1) The smaller the number, the	(default)
	higher priority the route has.
Check WAN	Enter the IP address of a reliable nearby computer (for example, your	0.0.0.0
IP Address	ISP’s DNS server address) to test your Prestige’s WAN accessibility.
	The Prestige uses the default gateway IP address if you do not enter an
	IP address here.
	If you are using PPTP or PPPoE Encapsulation, enter “0.0.0.0” to
	configure the Prestige to check the PVC (Permanent Virtual Circuit) or

10-4 Traffic Redirect