CHAPTER 19
Static Route
This chapter shows you how to configure static routes.
19.1 Configuring Static Route
Static routes tell the switch how to forward IP traffic when you configure the TCP/IP parameters manually.
Click IP Application, Static Routing in the navigation panel to display the screen as shown.
Figure 54 Static Routing
The following table describes the labels in this screen.
Table 36 Static Routing
LABEL | DESCRIPTION |
|
|
Active | This field allows you to activate/deactivate this static route. |
|
|
Name | Enter a descriptive name (up to 32 printable ASCII characters) for identification |
| purposes. |
Destination IP | This parameter specifies the IP network address of the final destination. Routing is |
Address | always based on network number. If you need to specify a route to a single host, use |
| a subnet mask of 255.255.255.255 in the subnet mask field to force the network |
| number to be identical to the host ID. |
IP Subnet Mask | Enter the subnet mask for this destination. |
|
|
Gateway IP | Enter the IP address of the gateway. The gateway is an immediate neighbor of your |
Address | switch that will forward the packet to the destination. The gateway must be a router on |
| the same segment as your switch. |
Chapter 19 Static Route | 111 |