ES-2108 Series User’s Guide

Figure 135 vlan1q port default vid Command Example

ras (config)# interface port-channel 1-5 ras (config-interface)# pvid 200

29.5.2 Set Acceptable Frame Type

Syntax:

frame-type <alltagged>

where

<alltagged> = Specifies all Ethernet frames (tagged and untagged) or only tagged Ethernet frames.

This command sets the specified port to accept all Ethernet frames or only those with an IEEE 802.1Q VLAN tag.

The following example sets ports 1 to 5 to accept only tagged frames.

Figure 136 frame type Command Example

ras (config)# interface port-channel 1-5 ras (config-interface)# frame-type tagged

29.5.3 Enable or Disable Port GVRP

Use the gvrp command to enable GVRP on the port(s). Use the no gvrp command to disable GVRP.

The following example turns off GVRP for ports 1 to 5.

Figure 137 no gvrp Command Example

ras (config)# interface port-channel 1-5 ras (config-interface)# no gvrp

29.5.4 Modify Static VLAN

Use the following commands in the config-vlan mode to configure the static VLAN table.

192

Chapter 29 IEEE 802.1Q Tagged VLAN Commands