ES-2108 Series User’s Guide

Table 59 interface port-channel Commands (continued)

COMMAND

 

DESCRIPTION

 

 

 

 

 

pvid <1-4094>

 

The default PVID is VLAN 1 for

 

 

 

all ports. Sets a PVID in the

 

 

 

range 1 to 4094 for the specified

 

 

 

interface.

 

qos priority

<0 .. 7>

Sets the quality of service

 

 

 

priority for an interface.

 

speed-duplex

<auto10-half10-

Sets the duplex mode (half or

 

 

full100-half100-

full) and speed (10, 100 or

 

 

full1000-full>

1000 Mbps) of the connection

 

 

on the interface. Selecting

 

 

 

auto (auto-negotiation) makes

 

 

 

one port able to negotiate with a

 

 

 

peer automatically to obtain the

 

 

 

connection speed and duplex

 

 

 

mode that both ends support.

 

test

 

Performs an interface loopback

 

 

 

test.

 

vlan-trunking

 

Enables VLAN Trunking on

 

 

 

ports connected to other

 

 

 

switches or routers (but not

 

 

 

ports directly connected to end

 

 

 

users) to allow frames

 

 

 

belonging to unknown VLAN

 

 

 

groups to pass through the

 

 

 

switch.

27.9.5 config-vlan Commands

The following table lists the vlan commands in configuration mode.

Table 60 Command Summary: config-vlan Commands

COMMAND

 

DESCRIPTION

 

 

 

 

vlan <1-4094>

 

 

Creates a new VLAN group.

 

exit

 

Leaves the VLAN configuration mode.

 

fixed <port-list>

 

Specifies the port(s) to be a permanent

 

 

 

member of this VLAN group.

 

forbidden <port-

 

Specifies the port(s) you want to

 

list>

 

prohibit from joining this VLAN group.

 

help

 

Displays a list of available VLAN

 

 

 

commands.

 

inactive

 

Disables the specified VLAN.

 

ip address

<ip-address>

Sets the IP address and subnet mask

 

 

<mask>

of the switch in the specified VLAN.

 

 

<ip-address>

Sets the management IP address and

 

 

<mask>

subnet mask of the switch in the

 

 

[manageable]

specified VLAN.

 

 

 

168

Chapter 27 Introducing the Commands