leave <msec>
leaveall <msec>
=This sets the duration of the Leave Period timer for GVRP in milliseconds. Each port has a single Leave Period timer. Leave Time must be two times larger than Join Timer; the default is 600 milliseconds.
=This sets the duration of the Leave All Period timer for GVRP in milliseconds. Each port has a single Leave All Period timer. Leave All Timer must be larger than Leave Timer; the default is 10000 milliseconds.
This command sets the switch’s GARP timer settings, including the join, leave and leave all timers.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join message using GARP. Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all registrations. GARP timers set declaration timeout values.
The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800 milliseconds and the Leave All Timer to 11000 milliseconds.
Figure 132 GARP Timer Command Example
ras (config)# garp join 300 leave 800 leaveall 11000
29.4.3 GVRP Timer
Syntax:
show vlan1q gvrp
This command shows the switch’s GVRP settings.
An example is shown next.
Figure 133 GVRP Status Command Example
ras # show vlan1q gvrp GVRP Support
gvrpEnable = YES GVRP Support
29.4.4 Enable GVRP
Syntax:
vlan1q gvrp
190 | Chapter 29 IEEE 802.1Q Tagged VLAN Commands |