Figure 109 CLI: boot config Command Example
ras# boot config
Use the reload config command to restart the system. The following figure shows an example.
Figure 110 CLI: reload config Command Example
ras# reload config
28.6.2 Resetting to the Factory Default
Follow the steps below to reset the switch back to the factory defaults.
1Enter erase running config to reset the current running configuration.
2Enter write memory to save the changes to the configuration file.
The following example resets the configuration file to the factory default settings.
Figure 111 CLI: Reset to the Factory Default Example
ras# erase
28.7 no Command Examples
These are the commonly used command examples that belong to the no group of commands.
28.7.1 no mirror-port
Syntax:
no
Disables port mirroring on the switch.
An example is shown next.
Chapter 28 Command Examples | 177 |