9.3 Resetting to Factory Defaults
If you’ve forgotten your password, or your camera’s been acting generally strange, you can follow the steps below to reset the camera to its default settings. To reset the camera:
1)Press and hold the reset button (located on the camera’s rear panel) for approximately 10 seconds. When successful, you should see the status indicator light turn off.
2)After approximately 5 more seconds, the status indicator light should turn on again. This indicates that the camera has been successfully reset to factory defaults.
3)Reconfigure your camera using the eaZy Wizard.
Once the camera is reset, it will take approximately 1 minute to reboot. Wait for it to finish, then load the eaZy Wizard to scan for the camera.
