ZyXEL Communications LTE6100 1.6 The RESET Button, LED, Table, COLOR, RESET, POWER, RESET, POWER, POWER, STATUS, DESCRIPTION

Chapter 1 Introduction

None of the LEDs are on if the LTE Device is not receiving power.

Table 1 LED Descriptions (From Left To Right)

LED	COLOR	STATUS	DESCRIPTION
PWR/SYS	Green	On	The LTE Device is receiving power and ready for use.
		Blinking	The LTE Device is booting up.
	Red	On	The LTE Device detected an error while self-testing, or there is a
			device malfunction.
		Blinking	The LTE Device is upgrading the firmware.
	Off		The LTE Device is not receiving power.
LTE	Green	On	The LTE Device has an LTE connection on the WAN.
		Blinking	The LTE Device is searching for a frequency channel or is performing
			network entry.
	Off		The LTE Device does not have an LTE connection on the WAN.
Signal			The LTE LEDs display the Received Signal Strength Indication (RSSI)
Strength			of the LTE connection. Three signals on at the same time means best
			signal quality, two means medium signal quality, and one means low
			signal quality.
		No Signal	There is no LTE connection.
		LEDS
	Green	Signal 1	The signal strength is less than -90 dBm if signal 1 is on only.
		On
		Signal 2	The signal strength is between -90 dBm and -70 dBm if both signals 1
		On	and 2 are on.
		Signal 3	The signal strength is -70 dBm or greater if three signals are all on.
		On
ETHERNET1	Yellow	On	The LTE Device has a successful 1000 Mbps Ethernet connection with
-2	(Giga		a device on the Local Area Network (LAN).
	Ethernet)
		Blinking	The LTE Device is sending or receiving data to/from the LAN at 1000
			Mbps.
	Green (Fast	On	The LTE Device has a successful 10/100 Mbps Ethernet connection
	Ethernet)		with a device on the Local Area Network (LAN).
		Blinking	The LTE Device is sending or receiving data to/from the LAN at 10/
			100 Mbps.
	Off		The LTE Device does not have an Ethernet connection with the LAN.

Refer to the Quick Start Guide for information on hardware connections.

1.6 The RESET Button

If you forget your password or cannot access the web configurator, you will need to use the RESET button at the back of the device to reload the factory-default configuration file. This means that you will lose all configurations that you had previously and the passwords will be reset to the defaults.

1Make sure the POWER LED is on (not blinking).

2To set the device back to the factory default settings, press the RESET button for 5 seconds or until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the defaults have been restored and the device restarts.

	15
LTE6100 User’s Guide