Chapter 1 Introduction

allows one device to authenticate the other) in each of the two devices. When WPS is activated on a device, it has two minutes to find another device that also has WPS activated. Then, the two devices connect and set up a secure network by themselves.

For more information on using WPS, see Section 5.2.1 on page 57.

1.5 Wall Mounting

You may need screw anchors if mounting on a concrete or brick wall.

Table 2 Wall Mounting Information

Distance between holes

12 cm

 

 

M4 Screws

Two

 

 

Screw anchors (optional)

Two

 

 

1Select a position free of obstructions on a wall strong enough to hold the weight of the device.

2Mark two holes on the wall at the appropriate distance apart for the screws.

Be careful to avoid damaging pipes or cables located inside the wall when drilling holes for the screws.

3If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way in - leave a small gap of about 0.5 cm.

If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the screws all the way in - leave a gap of about 0.5 cm.

4Make sure the screws are fastened well enough to hold the weight of the NBG-418N with the connection cables.

5Align the holes on the back of the NBG-418N with the screws on the wall. Hang the NBG-418N on the screws.

Figure 3 Wall Mounting Example

16

 

NBG-418N User’s Guide