Chapter 6 Wireless LAN
Table 33 Network > Wireless LAN > WPS (continued)
LABEL | DESCRIPTION |
Release | This button is only available when the WPS status displays Configured. |
Configuration | Click this button to remove all configured wireless and wireless security settings for WPS |
| |
| connections on the |
|
|
Apply | Click Apply to save your changes back to the |
|
|
Refresh | Click Refresh to get this screen information afresh. |
|
|
6.9 WPS Station Screen
Use this screen when you want to add a wireless station using WPS. To open this screen, click Network > Wireless LAN > WPS Station tab.
Note: Note: After you click Push Button on this screen, you have to press a similar button in the wireless station utility within 2 minutes. To add the second wireless station, you have to press these buttons on both device and the wireless station again after the first 2 minutes.
Figure 58 Network > Wireless LAN > WPS Station
The following table describes the labels in this screen.
Table 34 Network > Wireless LAN > WPS Station
LABEL | DESCRIPTION |
Push Button | Use this button when you use the PBC (Push Button Configuration) method to configure |
| wireless stations’s wireless settings. See Section 5.2.1.1 on page 58. |
| Click this to start |
| information synchronization. |
|
|
Or input station’s | Use this button when you use the PIN Configuration method to configure wireless station’s |
PIN number | wireless settings. See Section 5.2.1.2 on page 59. |
| Type the same PIN number generated in the wireless station’s utility. Then click Start to |
| associate to each other and perform the wireless security information synchronization. |
|
|
80 |
|
|
|