Chapter 5 Tutorials
5.3Enable and Configure Wireless Security without WPS on your NBG-418N
This example shows you how to configure wireless security settings with the following parameters on your
SSID | SSID_Example3 |
|
|
Channel | 6 |
|
|
Security | |
| |
|
|
Follow the steps below to configure the wireless settings on your
The instructions require that your hardware is connected (see the Quick Start Guide) and you are logged into the Web Configurator through your LAN connection (see Section 2.2 on page 17).
1Open the Wireless LAN > General screen in the
2Make sure the Enable Wireless LAN check box is selected.
3Enter SSID_Example3 as the SSID and select a channel.
4Set security mode to
Figure 42 Tutorial: Network > Wireless LAN > General
5Open the Status screen. Verify your wireless and wireless security settings under Device Information and check if the WLAN connection is up under Interface Status.
| 61 |
|
|