Chapter 4 Modes
•Universal Repeater: In this mode, the NBG-418N v2 (N) can be an access point and a wireless client at the same time. Use this mode if there is an existing wireless router or access point in your network and you want the NBG-418N v2 (N) to wirelessly relay communications from its wireless clients to the access point.
Figure 18 Universal Repeater
WLAN
AP
N
4.2 Setting your NBG-418N v2 to Router Mode
The NBG-418N v2 is set to wireless router mode by default. If it was changed and now you want to set it back, do the following procedure.
1Connect your computer to the LAN port of the NBG-418N v2.
2The default LAN IP address of the NBG-418N v2 is 192.168.1.1 in router mode (192.168.1.2 by default in non-router mode). In router mode, the NBG-418N v2 can assign your computer an IP address, so you must set your computer to get an IP address automatically (computer factory default) or give it a fixed IP address in the range between 192.168.1.3 and 192.168.1.254.
3After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and type the IP address of the NBG-418N v2 as the web address in your web browser.
4Log into the Web Configurator. See the Chapter 2 on page 17 for instructions on how to do this.
5Go to Maintenance > Sys OP Mode > General and select Router.Figure 19 Maintenance > Sys OP Mode > Router
NBG-418N v2 User’s Guide