Chapter 4 Modes
2The default LAN IP address of the NBG-418N v2 is 192.168.1.1 in router mode (192.168.1.2 by default in non-router mode). In router mode, the NBG-418N v2 can assign your computer an IP address, so you must set your computer to get an IP address automatically (computer factory default) or give it a fixed IP address in the range between 192.168.1.3 and 192.168.1.254.
3After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and type the IP address of the NBG-418N v2 as the web address in your web browser.
4Log into the Web Configurator. See the Chapter 2 on page 17 for instructions on how to do this.
5Go to Maintenance > Sys OP Mode > General and select Access Point.Figure 24 Maintenance > Sys OP Mode > AP
6A pop-up window appears providing information on this mode. Click OK in the pop-up message window. Click Apply. Your NBG-418N v2 is now in AP Mode.
Note: Wait while the NBG-418N v2 restarts, then log in to the Web Configurator again.
4.3.1Status Screen (AP Mode)
Click on Status. The screen below shows the status screen in AP Mode.
Figure 25 Status Screen (AP Mode)
NBG-418N v2 User’s Guide