|
| Chapter 7 LAN |
| Table 45 Network > LAN > DHCP Setup | |
| LABEL | DESCRIPTION |
| Pool Size | Enter the number of IP addresses to allocate. This number must be at least one |
|
| and is limited by a subnet mask of 255.255.255.0 (regardless of the subnet the |
|
| ZyXEL Device is in). For example, if the IP Pool Start Address is 10.10.10.10, |
|
| the ZyXEL Device can allocate up to 10.10.10.254, or 245 IP addresses. |
|
|
|
| DNS Server |
|
|
|
|
| First DNS Server | Specify the IP addresses of a maximum of three DNS servers that the network can |
| Second DNS | use. The ZyXEL Device provides these IP addresses to DHCP clients. You can |
| Server | specify these IP addresses two ways. |
| Third DNS Server | From ISP - provide the DNS servers provided by the ISP on the WAN port. |
|
| User Defined - enter a static IP address. |
|
| DNS Relay - this setting will relay DNS information from the DNS server obtained |
|
| by the ZyXEL Device. |
|
| None - no DNS service will be provided by the ZyXEL Device. |
|
|
|
| Apply | Click this to save your changes and to apply them to the ZyXEL Device. |
|
|
|
| Cancel | Click this to set every field in this screen to its |
|
|
|
"This screen has no effect if the DHCP server is not enabled. You can enable it in Network > LAN > DHCP Setup.
Use this screen to make the ZyXEL Device assign a specific IP address to a specific computer on the LAN. To access this screen, click Network > LAN > Static DHCP.
Figure 57 Network > LAN > Static DHCP
| 111 |
|
|