Chapter 11 Quality of Service (QoS)
Table 41 QoS Class Configuration (continued)
LABEL |
| DESCRIPTION |
Interface |
| Select from which Ethernet port traffic of this class should come. |
|
| Select Local for any traffic from the LAN. |
|
|
|
Order |
| Select an existing number for where you want to put this classifier to |
|
| move the classifier to the number you selected after clicking Apply. |
|
| Select Last to put this rule in the back of the classifier list. |
|
|
|
Ether Type |
| Select a predefined application to configure a class for the matched |
|
| traffic. |
|
| If you select IP, you also need to configure source or destination MAC |
|
| address, IP address, DHCP options, DSCP value or the protocol type. |
|
| If you select 8021Q, you can only configure a 802.1p priority level. |
|
|
|
Tag Configuration |
| |
|
| |
Assign |
| Select a queue that applies to this class. |
Classification |
| You should have configured a queue in the Queue Setup screen |
Queue |
| |
| already. | |
|
| |
|
|
|
Mark |
| Select a DSCP value with which the ZyXEL Device replaces the DSCP |
Differentiated |
| field in the packets. |
Services Code |
| If you select Auto Marking and there is a VLAN tag carried in the |
Point (DSCP) |
| |
| matched packets, the ZyXEL Device will replace the IP ToS field with | |
|
| |
|
| the 802.1p priority field. |
|
| Select default to set the DSCP value in the matched packets to 0. |
|
|
|
Mark 802.1p |
| Select a priority level with which the ZyXEL Device replaces the IEEE |
priority |
| 802.1 priority field in the packets. |
|
|
|
Tag VLAN ID |
| Select a VLAN ID number (between 0 and 4095) with which the ZyXEL |
|
| Device replaces the VLAN ID of the frames. |
|
|
|
Set Rate |
| Enter the transmission rate (in Kbps) for traffic that matches this QoS |
Control(kbps) |
| class |
|
|
|
Filter Configuration |
| |
Use the following fields to configure the criteria for traffic classification. | ||
|
| |
Source |
|
|
|
|
|
Address |
| Enter the source IP address in dotted decimal notation. |
|
|
|
Subnet Mask |
| Enter the source subnet mask. |
|
|
|
Port |
| If you select a protocol type, enter the port number(s) of the source. |
|
| 0 means any source port number. |
|
|
|
MAC Address |
| Enter the source MAC address of the packet. |
|
|
|
136 |
| |
| ||
|
|
|