Chapter 5 WAN Setup
5.5.2 Configuring More Connections Advanced Setup
To edit your ZyXEL Device's advanced WAN settings, click the Advanced Setup button in the More Connections Edit screen. The screen appears as shown.
Figure 31 WAN > More Connections: Edit: Advanced Setup
The following table describes the labels in this screen.
Table 13 WAN > More Connections: Edit: Advanced Setup
LABEL | DESCRIPTION |
RIP & Multicast | This section is not available when you configure the ZyXEL Device to be |
Setup | in bridge mode. |
|
|
RIP Version | RIP (Routing Information Protocol) allows a router to exchange routing |
| information with other routers. The version field controls the format and |
| the broadcasting method of the RIP packets that the ZyXEL Device sends |
| (it recognizes both formats when receiving). |
| supported; but |
| adequate for most networks, unless you have an unusual network |
| topology |
| This field is available only when you select ENET ENCAP. |
| Select the RIP version from RIPv1, RIPv2 and RIPv1v2. |
|
|
RIP | This field is available only when you select ENET ENCAP. |
Operation | Select Active to enable RIP. Otherwise, select Disable. |
| |
|
|
IGMP | Multicast packets are sent to a group of computers on the LAN and are |
Multicast | an alternative to unicast packets (packets sent to one computer) and |
| broadcast packets (packets sent to every computer). |
| IGMP (Internet Group Multicast Protocol) is a |
| used to establish membership in a multicast group. The ZyXEL Device |
| supports both IGMP version 1 and version 2. Select Enable to turn on |
| IGMP. Otherwise, select Disable. |
|
|
62 |
| |
| ||
|
|
|