2.2.1.5 The Reset Button
Use a pointed object to press this button in once to reset the VSG back to the factory defaults.
Note: All your custom configuration including the system usernames and passwords will be erased.
This will NOT delete the subscriber database or the
2.2.2 Front Panel LEDs
The following table describes the LEDs on the front panel. When turned on, all LEDs are green unless otherwise specified.
Table 1 Front Panel LEDs
LED | STATUS | DESCRIPTION |
|
|
|
PWR | On | The VSG is receiving power. |
|
|
|
| Off | The VSG is not receiving power. |
|
|
|
ALARM | On (Red) | There is a hardware failure. |
|
|
|
| Blink Once (Red) | The system is starting up. |
|
|
|
| Off | The system is functioning normally. |
|
|
|
LAN or WAN |
| |
|
|
|
LK/ACT | On | The port is connected to an Ethernet device. |
|
|
|
| Blinking | The port is receiving or sending data. |
|
|
|
| Off | The port is not connected to an Ethernet device. |
|
|
|
10/100 | On | The port is operating at 100 Mpbs. |
|
|
|
| Off | The port is operating at 10 Mpbs. |
|
|
|
FDX | On | The port is operating in |
|
|
|
| Off | The port is operating in |
|
|
|
2.2.3 Rear Panel
The power socket, the fan and a ventilation hole are located on the rear panel as shown next.
Note: Do NOT block the ventilation hole.
Figure 7 Rear Panel
38 | Chapter 2 Hardware Installation and Connection |