What is what | Operator's Manual CS 2512 |
What is what
6
7
4
14 9
5
8
4
11
15
3
1
2
12
14
10
The saw consists of the following component parts:
1.Hydraulic motor
The machine is powered by a 60 cubic centimetre motor. The motor has two parts, one of 50 cubic centimetres and a smaller part of 10. Two gears are obtained by using either just the large motor or both the large and small motors together. The two gears give different speeds, yet the same power.
2.Hydraulic hose connections
The hydraulic flow in the two large hoses drives the machine's motor and with that the wire. The flow in the two smaller hoses drives the magazine cylinder.
3.Drive wheel
Transfers the motive force from the motor to the wire. The drive wheel is 400 mm in diameter and is covered with replaceable rubber to give as good grip as possible between the drive wheel and wire.
The drive wheel forms together with the hydraulic motor and the hydraulic connections the drive wheel unit. The drive wheel unit is adjusted depending on how many wheel sets are used in the magazine. These can easily be dismantled to give a lighter machine during transporting.
4.Wire magazine
Tensions the wire and stores recovered wire. The wire magazine has a capacity to store a maximum of 12 metres of wire (2.4 metres per wheel set).
5.Magazine cylinder
The magazine cylinder tensions the wire in the magazine and with that governs cutting. The pressure in the cylinder is adjusted by means of the pressure reduction block fitted on PP 455E or RC 455.
6.Guard
The machine has a
7.Lifting handle
The folding handle is the perfect aid when transporting the machine.
8.Adjustable feet
Adjusted so the saw stands firmly. In total, the saw features 10 feet, six for horizontal cutting and four for the vertical position.
8 - English