Q&A（Continued）
Other
QThe noise grows louder after using the chair for a long time.
AThis may be a malfunction. Contact the nearest authorized service center for an inspection and repair.
QIs there a timer function?
ATo prevent overuse, the massage automatically ends around 16 minutes after starting. When the timer ends, the leg rest automatically lowers and the massage heads are stored.
Press 
to use again.
◦Take a break of around 10 minutes after
using for 16 minutes.
◦Do not use more than twice (30 minutes) per day.Yes.
QThe leg & sole massage section doesn’t get warm.
AThe“Foot Heat”warms the toe portion of the cloth. Place feet so that they are firmly pressed against the“Heat”
(heater) section.
Raise the leg & sole massage section during use so that soles of your feet touch this section to feel the heat from the heater section.
You can also place a blanket over your knees and lower legs to feel even warmer.
EN56
QWhat precautions should I take to transport the unit when moving?
ATake the following precautions:
◦Recline the backrest and raise the massage heads to around the center of the backrest. This moves the center of gravity to the center of the unit and makes
it easier to move.
◦Do not move the chair while a person is sitting in it.
①Press 
to turn the power on.
②Press 
to recline the backrest.
Hold down the two buttons until long beeps sound.
③Select an automatic course when the power is on.
◦The massage heads move. An error
occurs and the movement stops when they reach the center of the backrest.
Massage 
heads 
④Press 
to turn the power off.
◦Be sure to press 
, as 
automatically raises the backrest.
⑤Turn the power switch“off”and remove the power plug (see page EN45.)
If you need to move the chair with the backrest upright, follow the steps below.
(1)Follow steps ①→③→④ above and raise the massage heads to the center.
(2)Turn the controller power on again, raise
the backrest and press | to turn off the |
power. |
|
◦Handle the chair with care. If you do
not have the original box, use packing materials to prevent damage or vibration.
◦When packing, check that the power
cord and controller cord are not wrapped around the main unit and take measures such as placing them on the seat with the controller to ensure that they do not scrape against the ground while moving.