Ryobi RY34001 Troubleshooting, Problem Possible Cause Solution, See Adding/Checking Engine

Page 14

TROUBLESHOOTING

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.

PROBLEM

POSSIBLE CAUSE

SOLUTION

Engine will not start

No spark.

Clean or replace spark plug. Reset

 

 

spark plug gap. Refer to Spark Plug

 

 

Replacement earlier in this manual.

 

No fuel.

Push primer bulb until bulb is full of

 

 

fuel. If bulb does not fill, primary fuel

 

 

delivery system is blocked. Contact an

 

 

authorized service center. If primer bulb

 

 

fills, engine may be flooded, proceed

 

Engine is flooded.

to next item.

 

 

 

 

Set the start lever to the START position.

 

 

Squeeze the trigger and pull the rope

 

 

repeatedly until the engine starts and

 

 

runs.

 

 

NOTE: Depending on the severity of

 

 

the flooding, this may require numerous

 

 

pulls of the rope.

 

 

 

Engine does not reach full speed and

Air filter screen is dirty.

Clean air filter screen. Refer to Clean-

emits excessive smoke

 

ing Air Filter Screen earlier in this

 

 

manual.

 

Spark arrestor screen is dirty.

Contact an authorized service center.

 

Spark plug fouled.

Clean or replace spark plug. Reset

 

 

spark plug gap. Refer to Spark Plug

 

 

Replacement earlier in this manual.

 

 

 

Engine starts, runs, and accelerates

Idle speed screw on carburetor needs

Turn idle speed screw clockwise to

but will not idle

adjustment.

increase idle speed. See Figure 9.

 

 

 

Engine emits too much smoke

Too much oil in crankcase.

Drain lubricant and refill with correct

 

 

amount of 10W-30 engine lubricant.

 

 

See Adding/Checking Engine

 

 

Lubricant in the Operation section of

 

 

this manual.

 

 

 

Engine rope cannot be pulled

Oil has entered the combustion

This is usually caused by storing the unit

 

chamber.

for an extended time with the engine in

 

 

an upside-down position. Remove and

 

 

clean the spark plug. Drain the oil out

 

 

of the spark plug hole, then reinstall the

 

 

spark plug.

 

 

Check engine lubricant and add if

 

 

necessary prior to starting. Refer to

 

 

Changing Engine Lubricant earlier in

 

 

this manual.

 

 

 

12 — English

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Save this Manual for Future Reference Toutes LES Versions Todas LAS VersionesPage Iii Table of Contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules for ­BRUSHCUTTER and Blade USE Specific Safety RulesSpecific Safety Rules for Trimmer USE Symbol Name Explanation SymbolsSymbol Signal Meaning Features AssemblyOperation Removing AN Attachment from the Power HeadFueling and Refueling the Power Head Attaching the Front HandleOxygenated Fuels Operating the Power HeadDo not USE E85 FUEL. IT will Void Your Warranty ADDING/CHECKING Engine LubricantBlade Thrust MaintenanceGeneral Maintenance Starting and StoppingCleaning AIR Filter Screen Cleaning the Exhaust Port and Muffler Spark ArrestorIdle Speed Adjustment Spark Plug ReplacementStoring the Product Adjusting CAMSHAFT-TO-ROCKER ARM ClearanceWhen storing 1 month or longer High Altitude Engine OperationIng Air Filter Screen earlier in this TroubleshootingProblem Possible Cause Solution See Adding/Checking EngineWarranty Limited Warranty StatementMANUFACTURER’S Warranty Coverage This Product WAS Manufactured with a Catalyst Muffler English Lire Toutes LES Instructions Règles DE Sécurité GénéralesAvertissement Règles DE Sécurité Particulières Symboles Symbole NOM ExplicationCaractéristiques AssemblageRetrait ou remplacement de l’accessoire Installation DE LA Poignée AvantRetrait DE L’ACCESSOIRE DU BLOC- Moteur UtilisationUtilisation DU BLOC-MOTEUR Carburants OxygénésAJOUT/VÉRIFICATION DE Lubrifiant Démarrage ET Arrêt EntretienRicochet DE Lame Avertissement AvertissementRéglage DU Ralenti Bouchon DU RéservoirPARE-ÉTINCELLES Changer LE Lubrifiant À MoteurVoir les figures 13 à Remisage LE ProduitFonctionnement DU Moteur À Haute Altitude Remisage 1 mois ou plusDépannage Problème Cause Possible SolutionRemplacement de la bougie plus Section Nettoyage du filtre à airGarantie Énoncé DE LA Garantie LimitéeResponsabilités DU Propriétaire Dans LE Cadre DE LA Garantie ’AIDE? Fonctionnement Chaque annéeLEA Todas LAS Instrucciones Reglas DE Seguridad GeneralesAdvertencia Reglas DE Seguridad Específicas Precaución SímbolosPeligro Características ArmadoDesmontaje UN Aditamento DEL Cabezal Motor FuncionamientoMontaje DEL Mango Delantero Para desmontar o cambiar el aditamentoManejo DE EL Cabezal Motor Combustibles OxigenadosAbastecimiento Y Verificación DE Lubricante No USE Combustible E85. Anulará SU GarantíaArranque Y Apagado MantenimientoContragolpe DE LA Cuchilla Mantenimiento GeneralAjuste DE LA Marcha Lenta Limpieza DEL Orificio DE Escape Y DEL SilenciadorParachispas Limpieza DEL Filtro DE Aire PantallaOperación DEL Motor a Altitudes Elevadas Ajuste DE LA Apertura DEL Árbol DE Levas DEL BalancínAlmacenamiento DE LA Producto Vea las figuras 13 aSolución DE Problemas Garantía Declaración DE LA Garantía LimitadaCobertura DE LA Garantía DEL Fabricante Este Producto SE Fabricó CON UN Silenciador Catalítico 4050English Proposition 65 DE L’ÉTAT DE Californie Manuel D’UTILISATION / Manual DEL OperadorCalifornia Proposition California Propuesta DE LEY NÚM

RY34001 specifications

The Ryobi RY34001 is a versatile outdoor power tool designed for homeowners and DIY enthusiasts seeking reliable performance in a handheld leaf blower. This battery-powered leaf blower offers a convenient way to maintain your yard, driveway, and patio, eliminating debris and leaves effortlessly.

One of the standout features of the RY34001 is its powerful 40V lithium-ion battery. This battery technology provides a significant advantage over traditional gas-powered blowers, delivering consistent and potent power without the hassle of gas or oil mixtures. Users can enjoy longer run times, enabling them to complete their yard work without interruptions. Additionally, the battery charge time is relatively quick, allowing users to get back to their tasks without long waits.

The RY34001 is designed with an impressive air volume rating of up to 540 CFM (cubic feet per minute) and an air speed of up to 130 MPH. This combination ensures that it can easily tackle heavy debris and wet leaves, making it perfect for both light clean-up tasks and more demanding jobs. The variable speed trigger allows users to adjust the airflow to suit their specific needs, whether they are moving light grass clippings or dealing with stubborn, wet piles of leaves.

Another notable characteristic of the Ryobi RY34001 is its ergonomic design. The blower features a lightweight construction, making it easy to handle and maneuver during operation. This design is complemented by a comfortable grip, reducing fatigue during extended use. The unit also includes a built-in cord retainer to prevent accidental disconnection, further enhancing user experience.

Ryobi has incorporated their patented technology into the RY34001, ensuring it delivers reliable performance time after time. The unit is also compatible with other Ryobi 40V tools, making it a valuable addition to a growing collection of outdoor equipment. With the RY34001, users can embrace a clean and well-maintained yard with the convenience of battery power, proving that efficiency and performance can go hand in hand. Whether you have a small garden or a larger property, the Ryobi RY34001 leaf blower is an excellent tool for simplifying yard maintenance.
Top Page Image Contents