Polaris P2000i, P1000i manual Operation

Page 36

OPERATION

Safe Operating Precautions

DC Operation

Connecting the Battery Charging Cable (included)

1.Position the SMART throttle switch to OFF.

2.Disconnect the vehicle ground cable from the negative (-) battery terminal.

3.Plug the battery charging cable into the DC receptacle. See page 19.

4.Connect the red lead of the battery charging cable to the positive (+) battery terminal and then the black lead to negative (-) battery terminal.

Start the generator

Do not start the vehicle while the battery charging cable is connected and the generator is running. The vehicle’s charging system or the generator may be damaged.

An overloaded DC circuit, excessive current draw by the battery, or a wiring problem will trip the DC circuit fuse. If this happens, The fuse must be replaced before the DC receptacle is operative. Replace the fuse with one of the same size and rating (5 amp). Exceeding the current rating may lead to alternator damage. If the DC circuit protector fuse continues to trip, discontinue charging and see your authorized POLARIS generator supplier.

The circuit protector does not prevent overcharging the battery. Over charging the battery may result in battery damage and potential ignite if a spark is introduced.

35

Image 36
Contents Polaris Power Table of Contents Introduction WelcomeIntended Use Safety Precautions Signal Words and Safety Terms Alcohol or Drug USEIdentification Numbers and Locations P1000iP2000iSafety Safety Warnings and PrecautionsGeneral Before and During OperationFire Safety Operator Safety Fuel Safety Carbon Monoxide Safety Electrical Safety Extension Cord Information Equipment ModificationsSafety Labels and Locations Carbon Monoxide WarningOutdoor Use only Danger Label Hot Exhaust CautionSafety Controls and Features Generator ComponentsControl Panel Components P1000i P2000iEngine Fuel Switch Choke LeverFuel Tank Cap Vent Lever Starter Recoil GripSmart Throttle Switch DC Receptacle and FuseIndicator Panel Ground TerminalAC Receptacles Overload Protector Reset Switch Parallel ReceptaclesFirst USE Instructions Adding Engine OilFuel Recommendation Adding Fuel Pre-Operation Checklist PRE-OPERATION InspectionSafe Operating Precautions OperationFuel Recommendations RefuelingRemove the fuel tank cap a Before Starting the Engine Starting the EnginePosition the engine switch to on Stopping the Engine AC Operation AC Capacity Wattage Reference Table Power Management DC OperationOperation Disconnecting the Battery Charging Cable Smart Throttle SystemStandby Power Connections to a Building Electrical SystemParallel operation procedure Parallel Generator OperationShutting off the generators High Altitude Use Carburetor ModificationEmission Control System Information Source of EmissionsAlterations Problems Affecting Emissions Replacement PartsMaintenance Importance of MaintenanceMaintenance Safety Safety PrecautionsPeriodic Maintenance Periodic Maintenance ChartOpening the Service Door Initial Maintenance Fuel SystemHour Initial Break-In Fuel Line InspectionOFF Engine Oil Oil RecommendationOil Level Inspection Oil Change Procedure Maintenance Air Filters Air Filter InspectionAir Filter Cleaning Air Filter ReplacementSpark Plug Inspection and Replacement Spark PlugGap should be 0.6 0.7 mm Transportation and Storage TransportationTransporting the Generator Storage Storage PreparationAccessing the Fuel Tank Draining Fuel from the Fuel Tank and Carburetor Fogging the Engine Storage Precautions Removing from StorageSpecifications General SpecificationsPolaris Lubricants and Maintenance Products Modified coefficient table of ambient condition powerWiring Diagrams P1000i Wiring DiagramP2000i Wiring Diagram Red Gray Brown White BlackTroubleshooting Troubleshooting SymptomsEngine Will Not Turn Over Engine Turns Over, but Will Not StartEngine Lacks Power Engine BackfiresEngine Pings or Knocks Engine Runs Irregularly, Stalls, or MisfiresNo Power at DC Receptacle Possible Lean Solution Fuel CauseNo Power at AC Receptacles Engine Stops or Loses PowerWarranty About this Warranty Document Warranty Registration FormWarranty Period Warranty Exclusions Polaris Power Generator Owner Responsibility Important Notice Maintenance LOG DATE/HOURS Service Comments Supplier Permormed TechnicianIndex Label LocationIndex PMS